学车入门篇（Learn introductory article）.docVIP

学车入门篇（Learn introductory article） Car entry: (launch vehicle, start, speed and stop) A launch vehicle Launch vehicles, a total of four steps: 1, the clutch pedal. 2, check whether the gear lever in the neutral position, if not in neutral, should be the shift lever into neutral. 3, the foot pedal is stepped down to a little will accelerate. 4, connect the starter circuit. Note: as long as the engine after starting, it must quickly switch the key will loosen, loosen the switch keys at the same time, to raise the pedal will accelerate (winter or cold start when not all up, the engine should be kept low speed, preheating) otherwise, will reduce the service life of the starter. Two, the vehicle starting The starting time of eight steps: 1, the clutch pedal. 2, the shift lever hangs in a position. 3, open the steering lamp switch (with the left rear left rearview mirror to confirm safety) 4, horn. 5, release the parking brake. 6, add a little bit of right foot throttle, keep the engine at the start of adequate. 7, lift the clutch pedal (in the process of starting lift the clutch pedal in the road, as long as found the car began to move, then the clutch entered the linkage region, must stop, 1 mm can lift, if the vehicle is not carried, rush is the engine flameout, and train more than 5 meters, and then the clutch pedal slowly all up, so the vehicle at the start) is very smooth. 8, the car into the lane, off the steering lamp switch. Three, speed 1, add file: after the start of the car into the normal route, trample the accelerator pedal, the speed increased to a high ratio of the gear gear speed range, then the clutch pedal, the accelerator pedal (lift the clutch pedal and the accelerator pedal must be lifted at the same time.), rapid transmission the rod in the neutral position, the gear lever in the neutral position for 1 seconds, quickly changed into a high lever position, then lift the clutch pedal, the clutch pedal linkage but carried to the point, to stop 2-3 second