friction experiments for dynamical coefficient measurement摩擦对动力系数的实验测量.pdfVIP

Hindawi Publishing Corporation Advances in Tribology Volume 2011, Article ID 613581, 6 pages doi:10.1155/2011/613581 Research Article Friction Experiments for Dynamical Coefficient Measurement J. J. Arnoux, G. Sutter, G. List, and A. Molinari Laboratoire de Physique et Mecanique des Materiaux, FRE CNRS 3236, Ile du Saulcy, 57045 Metz Cedex 01, France ´ ´ Correspondence should be addressed to J. J. Arnoux, jjarnoux@univ-metz.fr Received 30 November 2010; Revised 1 February 2011; Accepted 10 May 2011 Academic Editor: Dae Eun Kim Copyright © 2011 J. J. Arnoux et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. An experimental study, including three experimental devices, is presented in order to investigate dry friction phenomena in a wide range of sliding speeds for the steel on steel contact. A ballistic setup, with an air gun launch, allows to estimate the friction coefficient between 20 m/s and 80 m/s. Tests are completed by an adaptation of the sensor on a hydraulic tensile machine (0.01 m/s to 3 m/s) and a pin-on-disk tribometer mounted on a CNC lathe (1 to 30 m/s). The interactions at the asperity scale are characterized by a white light interferometer surface analysis. 1. Introduction on CNC lathe, (2) a friction device installed on a rapid hydraulic machine, and (3) an experiment performed by Friction is a crucial parameter in many engineering appli- using a ballistic device (gas launcher). The