burst error correction method based on arithmetic weighted checksums基于算术加权校验和纠错方法.pdfVIP

Engineering, 2012, 4, 768-773 /10.4236/eng.2012.411098 Published Online November 2012 (http://www.SciRP.org/journal/eng) Burst Error Correction Method Based on Arithmetic Weighted Checksums 1 2 Saleh Al-Omar , Atef Obeidat 1Department of Engineering, Amman Private University, Amman, Jordan 2Department of Information Technology, Al-Balqa Applied University, Irbid, Jordan Email: salehalomar@ Received July 19, 2012; revised August 23, 2012; accepted September 4, 2012 ABSTRACT In this paper a new approach for increasing the performance of burst error correction that occurs during data transmis- sion in low-frequency channels with pulse-code modulation is proposed. The specific technique is based on the weighted checksum which is computed with arithmetic operations. It is shown that the solution proposed not only guarantees the correction of any single error burst but it also lowers the computational complexity so that procedure correction time does not depend on controlled data block length. Finally, the use of the algorithm is illustrated via the thorough presentation of an example of erroneous data transmission. Keywords: Burst-Errors; Reed Solomon; Arithmetic Weighted Checksum 1. Introduction control bits and possibilities of detecting and correction errors in rate data transmission. It is clear that in modern The development of the information transmission tech-