diabetic diagnose test based on ppg signal and identification system糖尿病诊断测试基于ppg信号和识别系统.pdfVIP

Vol.2, No.6, 465-469 (2009) JBiSE doi:10.4236/jbise.2009.26067 Diabetic diagnose test based on PPG signal and identification system Hadis Karimipour1 1 2 , Heydar Toossian Shandiz , Edmond Zahedi 1School of Electrical Engineering, Shahrood University of Technology, Shahrood, Iran; 2School of Electrical Engineering, Sharif University of technology, Tehran, Iran. Email: h_karimipour@; zahedy@ Received 11 May 2009; revised 29 June 2009; accepted 6 July 2009. ABSTRACT devices for measuring oxygen saturation, blood pressure and cardiac output [5]. Due to change in glucose level, In this paper, photoplethysmogram (PPG) sig- the amount of blood volume in the figure changes, this nals from two classes consisting of healthy and variation can be measured by PPG. When a fixed source diabetic subjects have been used to estimate of infrared radiation is used, the variation of blood vol- the parameters of Auto-Regressive Moving Av- ume act as a phototransistor and the receive signal is erage (ARMA) models. The healthy class con- changed. This is why we use the PPG signal for recog- sists of 70 healthy and the diabetic classes of 70 nizing the diabetic. In this work by filtering on pho- diabetic patients. The estimated ARMA parame- toplethysmography (PPG) signal and estimate ARMA ters have then been averaged for each class, model for healthy and patient