泡沫陶瓷填料湿化器的流体力学和传热传质性能-中国电机工程学报.PDF

第33 卷 第5 期 中 国 电 机 工 程 学 报 Vol.33 No.5 Feb.15, 2013 68 2013 年2 月15 日 Proceedings of the CSEE ©2013 Chin.Soc.for Elec.Eng. 0258-8013 (2013) 05-0068-05 TK 47 A 470 30 文章编号： 中图分类号： 文献标志码： 学科分类号： ⋅ 泡沫陶瓷填料湿化器的流体力学和传热传质性能 徐震，路源，肖云汉 ( 中国科学院先进能源动力重点实验室(工程热物理研究所) ，北京市 海淀区 100190) Hydrodynamic and Heat and Mass Transfer Performances of the Foam Ceramic Packing Humidifier XU Zhen, LU Yuan, XIAO Yunhan (Key Laboratory of Advanced Energy and Power, Chinese Academy of Sciences (Institute of Engineering Thermophysics), Haidian District, Beijing 100190, China) ABSTRACT: Humidifier is one of the key units in humid air 0 引言 turbine cycle. An experimental facility for packing humidifier 湿空气透平(humid air turbine，HAT)循环是基 was built in order to study the affection of novel packing on 于燃气轮机的先进热力循环的重要研究发展方向 humidification. The pressure drop, flooding properity and height of gas-phase mass transfer unit for TC-1 and traditional 之一[1] 。湿化器是HAT 循环的关键部件，起到充分 structured packing were tested at different gas velocity and 回收利用系统排气中低温余热，更经济的增加透平 water/air ratio. For TC-1, the pressure drop is about 2 times, the 工质流量，从而大幅增加循环比功和效率的作用， flooding gas velocity is 50%, and the height of gas-phase mass 其性能优劣对循环总体性能至关重要。 transfer unit is no more than 36.8% of structured packing, 湿化器中，水与压缩空气逆流直接接触，在沸 which show that although TC-1 has low capacity, but its heat 点以下变温蒸发，以最小化的火用损失实现空气加热 and mass t