园林水池(上)（Garden pond (top)）.docVIP

园林水池(上)（Garden pond (top)） * from the point of view of engineering cost, filtration and replacement of water bodies, maintenance and safety of equipment, the fountain should not be deep. Shallow pool is to pay attention to the hidden pipeline equipment, but also pay attention to shallow water, heat absorption is large, easy to algae. * general sprinkler installation, underwater lighting layout, water depth of 50~60 cm is enough. If imported equipment, but also shallow. Less than 40 cm, underwater light is not easy to install. A shallow water basin or the shallow pool, to more than 10 cm depth. * when the vertical submersible pump is used as power, the pump can be deepened locally to form a pump pit. At this time to ensure that the upper limit intake pump was above 50 cm depth. It is therefore desirable to use a small, inlet potential pump as far as possible. * because of the lowest elevation of the pump pit, it often becomes a sump pit, and the ATM inlet is located here. This is detrimental to the use of the pump. There is no filter screen above the pump sump. When possible, it is better to use horizontal potential pumps. Now, the joint venture factory in Jiangsu (Ge Lanfu) already sells this kind of products. * it was suggested that the water would overflow when the jet was stopped, or, conversely, whether the surface elevation would decrease as it began to spray, which was generally not apparent in practice. Even if the water surface drops, some are often ignored because of fluctuations in the surface of the water. But the multistage elevation of the fountain, after stopping spraying, water will still gradually fall under the pool at the bottom of the pool, when the water is relatively large. The elevation of the overflow should be raised up to 15~30 cm (preferably calculated by water volume), so as not to waste water every time the jet is opened. At the same time, it is felt that the pool is very deep and there is no intimacy. The width of the jet from the apex t