压力机设计（Press design）.docVIP

压力机设计（Press design） Calculation of function design of mechanical press 2007/6/15/09:32 Existing users comments 0 into the Forum Abstract this paper introduces the design of large mechanical press function in determining the quantity of work, the main motor power and the inertia of the flywheel drive, and on the basis of research and application of Komatsu technology, summed up the simple formula to complete the more complex operation, time-saving, reliable and practical. Keywords mechanical press; work done; main motor; power flywheel; moment of inertia; Large closed type single and double action mechanical press for the successful design of the volume is an important parameter, this parameter is the sum of several aspects of work, and there is a certain relationship between it and the main motor, flywheel, the operation is very complex. On the basis of the study of Komatsu technology, a simple formula is adopted to determine the work done in the design of the press, the power of the main motor and the inertia moment of the flywheel. This formula can be applied to closed type four point single action, double action or multi link mechanical press for nominal force 2000kN or more, slide block travel 400 to 1000mm. Through the analysis of the Komatsu press about different types of parameters such as the nominal pressure stroke force, slider stroke and cushion and the main motor power calculation, calculation and complicated formula is same or similar, so the formula is time-saving, reliable and practical. For example, the following table (are introduced Komatsu products). The parameters of E4S600 E4S1000 E4D800+500 E4D600400 Male weigh strength KN 600010000 inside slide outside slider Inslider sliderPressure stroke Mm 1313136136 Maximum available The work done is J 1.8 * 105 *3.7 * 105 3.8 x 1052.6 x 105 *4 * 105 3.7 x 105 Slider travel Mm 600100094066094069 Stroke times 13 and 2010 min-1 ~ 1610 and 15 10 and 15 Air cushion force KN 1000150010001500