socket编程的注意事项（Socket programming notes）.docVIP

socket编程的注意事项（Socket programming notes） Socket programming notes: 1. connection timeout Not recommended M_socket = new, Socket (fm_ipaddr, fm_port); M_socket.setSoTimeout (180000); / / read data timeout 3M The above method, when the other side of the port is down, the client will have been waiting for the connection, and will not throw an exception. So the timeout was not at all Recommended wording: M_socket = new, Socket (); M_socket.setSoTimeout (180000); / / read data timeout 3M M_socket.connect (New InetSocketAddress (fm_ipaddr, fm_port), 2000); / / connect timeout 2., in the flow operation, it is best to add the following judgments M_socket.sendUrgentData (0xFF); / / decide whether the network is disconnected 3. do you want to close the output stream and the input stream? For the same socket, if the output stream is turned off, the socket associated with the output stream is also closed. So generally do not need to close the flow, directly close the socket on it. The above has been proved feasible by practice. This article from CSDN blog, reprinted please indicate the source: /e3002/archive/2009/01/17/3806984.aspx Socket Programming Notes Port number of UDP-----socket The clients socket rarely calls bind () to indicate the port number of the socket. Rather, the operating system is automatically assigned a port number. The port number of the TCP client socket is called after the connect (), and the system automatically assigns the port number. The port number of the UDP client socket is that after the first call to SendTo (), the system automatically assigns the port number. If the port of UDP is automatically allocated, then the system will no longer change the port number. If the IP address of UDP is also automatically allocated, then each call to the SendTo () system may change the source IP address based on the destination IP address. Weak, end, system, VS, strong, end, system The network interface will accept all packets that are consistent with the local I