发电厂汽轮机一些知识（Some knowledge of steam turbines in power plants）.docVIP

下载本文档

3
0
约1.85万字
约 17页
2017-08-31 发布于河南
举报
版权申诉

发电厂汽轮机一些知识（Some knowledge of steam turbines in power plants）.doc

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

发电厂汽轮机一些知识（Some knowledge of steam turbines in power plants）

发电厂汽轮机一些知识（Some knowledge of steam turbines in power plants） First preparation 1 confirm the gas tightness test of generator. 2 confirmation of lubricating oil system for normal operation, barring outage. 3 make sure the sealing oil system is working properly and the hydrogen / oil pressure difference is normal. 4 make sure the hydrogen moisture detector is isolated. Two replace the air with CO2 1 connect the CO2 cylinder to the CO2 bus. 2 open the feeding mother tube to the hydrogen analyzer, manual door, hydrogen analyzer inlet, manual door, hydrogen analyzer, exhaust manual door. The hydrogen analyzer is put into the CO2 test loop 3 turn off the gas dryer inlet, manual and gas dryer, exit the manual door, turn on the gas dryer, and bypass the manual door 4. Turn on the feeding mother tube to the generator manual door, hydrogen discharge mother tube, manual master door, CO2 bus dryer, front and rear manual door, CO2 mother tube to generator, manual door one or two times. The remaining valves are closed. 5 send the power supply of CO2 electric heating device and put into operation 6 use pressure reducing valve to adjust CO2 flow to control the pressure and temperature, the pressure after the pressure valve is maintained at 0.5 ~ 0.8MPa. 7 adjust the feed from the mother tube to the flame eliminator, the hydrogen exhaust manual door opening, so that the gas pressure in the machine is maintained at 0.01~0.02Mpa 8 when the CO2 cylinder frost, can water shower. 9 when the purity of CO2 reaches 85%, the gas pressure in the generator is properly increased, and then the dead ends are operated. (such as hydrogen dehumidification device, oil and water detection alarm and pipeline dead angle, etc.) exhaust air at the dead corner 10 stop the CO2 heating device and disconnect the power supply. Three hydrogen operation 1 close the feeding line, manual sampling door, CO2 bus dryer, front and rear manual door, CO2 master tube to generator, manual one or two door, feeding mother t