复印机代码（Copier code）.docVIP

复印机代码（Copier code） According to the input tray down button, the following actions are repeated. Press the button - feeder table - to rise limit switch - feeder table stop press feeder table drop - - lower limit switch to stop - feeder table 103 printing position of the motor forward / reverse. Back to the center vertical position, pause one second to one second pause - return reversal pause a second vertical center position, stop 104 on / off. The splint splint drum is rotated to the original position, open the splint (180 degrees), pause for a second, close the splint (0 degrees), roll back to the original position (the first step) 105 automatic document feeder operation. Pick up the original color correction release - input document - - - original original exit detection sensor is turned on to return to the first step up. 106 secure operation: the secret operating pressure on the electromagnetic pressure - - - (the electromagnet release continuous motion of three over the same period, the machine stops) 107 paper and printing operations: feeder table rises, continuous feed paper, until the 1. counter does not run out of paper printing, no jam detection without paper automatic feeder table 2. down 3. for the 4. ink printing speed and the density of key operation 108 platform read stepper motor (scanning) operation: scan the original position sensor compensation sensor platform scanner - - ADF - scanning position scanning original position sensor - cycle (click STRRT button to stop) 109 machine running the drum to 130 RPM running -A sensor to detect the stop after 3000 times, 110 lifting system running in: the rise of the sensor is connected with upper limit - - stop down limit sensor connected to stop up stop - - 111 thermal print head pressure motor: if the switch is pressed in situ thermal print head: thermal print head down - thermal printing pressure switch is pressed, stop: if the thermal head pressure switch is pressed: the therm