Fujikura 19S Fusion Splicer Fiber Optic（Fujikura 19 s熔接光纤）.pdf

Fujikura 19S Fusion Splicer The Fujikura 19S is a low cost, fixed v-groove single fiber splicer with similar features found on the Fujikura 70S. Incorporating the proven ruggedized features pioneered by Fujikura, the 19S has added automated and enhanced user control features to increase splicing efficiency. A user programmable, automated wind protector expedites the splicing process by automatically closing to initiate the splice process, and opening upon splice completion. Fully programmable “auto open sheath clamps” open one sheath clamp, after the tensile test, to prepare the fiber for removal. A new automated “clamshell design” tube heater applies heat to both sides of the splice protection sleeve resulting in a faster shrink time. Ruggedness and durability are greatly enhance by a mirror-less 19S optical system and severe-impact resistant monitor. An innovative transit case doubles as a built-in or mobile workstation and makes splicing easier than ever before. Features • Automated and programmable wind protector • Fully ruggedized for shock, dust and moisture • Li-ion battery with 180 splice/heat cycles per charge • 5 mm cleave length for splice on connector or small package needs • Sheath clamp or fiber holder operation In case with lid detached • On-board training and support videos