神油dds使用（God oil DDS use）.docVIP

神油dds使用（God oil DDS use） The world is on the low-end DDS compensation reduced magnification increase magnification to high-end, to balance the output amplitude, DDS used directly set the frequency can be, the screen display is the desired frequency for example if 10.7m receives the frequency 30m so DDS if -10.7m is the set of actual output mode of 40.7m, the screen display is the actual 30m the receiving frequency, rotary encoder can adjust the frequency change frequency Debugging of DDS The DDS control chip pic16f628a-1 and pic16f628a-2 ver4.06 have written procedures, all the installation is complete, access 5V working power supply, adjust the contrast of the 10K potentiometer, under normal circumstances can see the characters on the screen, if not normal, please measure and display part working voltage. This set of voltage polarity protection, so it will not burn your chip. If LCD cannot display characters, please try changing PIC16F628A, because the program in the two chip is different. Please install it according to the number I marked on the component. Three, DDS button description and operation steps: 1, button interface instructions: Enc code switch pin MEM storage mode conversion The VFO VFO A is converted to VFO B, or converted from VFO B to VFO a. SSB working mode conversion, USB LSB, am, CW, loop conversion. RIT fine tuning receiving frequency. Step step adjust button. Cal function settings button. KB-1 and KB-2 both have a common pin, but not the ground wire. Please pay attention to it when you install it. 3, hold down the cal key, power on, enter the initial settings interface, and release the cal key. A:enable 6xrefcle: set the chip clock mode, adjust the frequency encoding switch settings, AD9851 set to 6 octave, AD9850 set to 1 octave, short press cal to enter the next item. B:dds-system-clk: chip operating frequency settings, adjust the encoding switch to change the values, with the step button to adjust the step, AD9851 is set to 6 times the value