胶囊填充机原理（Capsule filling machine principle）.doc

胶囊填充机原理（Capsule filling machine principle） 2) check that all safety settings are properly equipped and properly adjusted. 3) in the absence of capsules and powder under the conditions, with the hand wheel in accordance with the direction of the machine rotation 1-3. After its normal, the capsule and powder are respectively loaded into the capsule bucket, and the powder filled in the height of the powder bucket is lower than the highest 60mm of the container. At the same time, there should be more than half of the powder in the measuring and distribution room. 4) adjust the filling rod and insert the depth of the metering disk. 5) after all adjustment, press the main engine to move, move normally, and then start the switch for automatic operation. 6) the speed adjustment is performed at the main motor operation. 1.3.3 operation 1) check the signal lamp is normal, close the glass machine door. Switch the main power switch SB10 from OFF to ON position, the indicator light HL4 and HL5 are bright, and the frequency converter is also displayed accordingly. 2) first start the vacuum pump motor M2, press the vacuum start switch SB1, the indicator light HL1, HL4 dark, the vacuum pump motor running. The first boot to check the direction of motor rotation, if the direction is wrong, to change the power phase sequence. 3) the running state of the main motor is divided into two states: inching operation and continuous operation. A. start the main motor M1, press the host start switch SB3, the indicator light HL3, HL5 dark, the main motor running. When the vacuum pump motor does not start or the machine opens the door, the main motor can not start, only wait for electric operation B. the main motor running point, press the host point action switch SB6, the indicator light HL3, or dark, the main power Machine operation, release the host point, move SB6, the indicator light HL5, HL3 dark, the main motor stops, the first boot should first.. Point running, the rear can run continuous