胶版印刷过程的常见印刷故障及解决方法（Common printing faults in offset printing process and Solutions）.doc

胶版印刷过程的常见印刷故障及解决方法（Common printing faults in offset printing process and Solutions） In the printing process all sorts of breakdown appears, generally speaking, rarely by single factor cause, because of the ink, the paper, the printing machine as well as the printing environment condition is uncoordinated, affects mutually. Here on the common printing failure, from the perspective of ink solutions, for your peer reference. 1, from dirty Dirty means that there is a lot of ink stains in the non printing area of printed matter. It is a common and typical fault in lithography. This phenomenon by a variety of factors of ink, paper, printing, printing and other medicine influence, from the angle of ink said, usually appear in the ink thin and soft, the yield value is too high, viscosity under the condition of insufficient performance to improve the ink viscosity, adding resin amount of inking oil or light mortar. Helps to overcome the dirty; ink matching, desiccant, low viscosity ink oil, adhesive adding too much ink will thin, viscous and small, is an important cause of the disadvantages of the ink prepared properly can solve, for fast light ink. Secondly, the plate mesh is not uniform, with grinding material residue, non sense fat deficiency, the layout of partial oxidation, or the developing shortage, also play an important factor caused by dirty, should also be examined and resolved at the same time, the printing machine roller are arranged side, dirty water roller, roller rubber aging, rubber cloth relaxation, will resulting from the dirty, should check and adjust. 2, lifting thickness Thickness refers to the pigment separated from the ink, piled on the plate and blanket, resulting in the printing dot paste. Under normal circumstances, the ink is bad water resistance, easy to emulsify, often appear this phenomenon. You can add an appropriate amount of high viscosity resin inking oil, light mortar or printing varnish, improve the ink viscosity, transfer and water resis