TUTORIAL Drawing a little mechanical part using （教程画一个小机械部分使用）.pdfVIP

TUTORIAL Drawing a little mechanical part using LibreCAD Tutorial by Claudio Guarnieri CLAUDIO GUARNIERI: Drawing a little mechanical part using LibreCAD – Page 1 of 17 Introduction Hello everyone! This tutorial is a tutorial for beginners and is made mainly for people that are not into LibreCAD, with the aim to help them to familiarize with it and to have the opportunity to create immediately something reasonably “productive”. LibreCAD has not yet a real completed manual, this task has taken in charge by a group of brave men, but you can find some piece of advice into the forum; moreover, even LibreCAD has been totally rebuilt, an idea of its use can be found on Qcad manual. Here Im using the version 2 of LibreCAD. This tutorial is also for people that simply need a quick review about the programs commands. In this little tutorial then, we are going to draw a little part in order to get people more into LibreCAD. I suggest to people that have no idea about this program works, to spend a little time playing with this nice program, I mean, the menus, the lists (block list and library browser), the command line, the sub-menus, and so on. People used to other cads will find easier to understand the icons logic. Finally I would like to thank Mr. Rallaz of the developers team, that gave me the drawing we are going to replicate, in fact even if I can use this LibreCAD Im not in mechanics, so I needed something understandable realistic to draw... Thanks Rallaz then! Now we can start our little journey in this drawing. Have fun! Claudio CLAUDIO GUARNIERI: Drawing a little mechanical part using LibreCAD – Page 2 of 17 Getting started Well, we have our prog