施工管理实务（Construction management practice）.docVIP

施工管理实务（Construction management practice） 2013 latest two construction division management and practice examination key minutes I. technical requirements for Construction Engineering In the course of building decoration, if there is structural change or increase load, should pay attention to: 1., involving the main body and load-bearing structure, must be the original design unit or the corresponding qualification of the design unit to verify the relevant raw materials, 2. building decoration construction, It is strictly forbidden to alter the building main body and the load-bearing structure or main functions without violating the design documents; and it is strictly forbidden to modify the water, heating, electricity, gas and communication facilities without the approval of the design and the approval of the relevant departments. 2. span maximum displacement: F=5QL4/384EI Besides the load, the displacement factors include material performance, component section and structure Piece span. For a class of 5., two, and three kinds of environment, design life of concrete structure for 50 years, the maximum water cement ratio, the minimum amount of cement, the minimum strength grade of concrete, the maximum chloride content and maximum alkali content requirements. 2. when the beam longitudinal stress of reinforced concrete grade is C20 The thickness of longitudinal reinforced concrete protection layer is 300mm; When the concrete grade is not less than C25, the protective layer thickness of 25 mm, and less than the diameter of D steel. 6. in the longitudinal strength of concrete C20, concrete protective layer is 20mm level greater than or equal to C25, the protective layer thickness of 15mm Two, multi story masonry house: 2. transverse walls shall meet the following requirements (rigid, rigid, flexible) 1) when opening a hole, the area is not more than 50% of the cross wall area 2) the thickness should not be less than 180mm 3) the length of the transverse wall of a single