无线网桥设置方法（Wireless bridge setting method）.docVIP

无线网桥设置方法（Wireless bridge setting method） For now, each one in the computer network of people, is one of the most important part of the computer and the collocation notebook computer is indispensable, so. The design of notebook computer is to design mobile office, network and office are inseparable, but for those of us notebook computer users often use such a problem: sometimes only one network interface, but there are many computers to access the Internet, it should be how to do? The answer is simple, you can use wireless sharing online. Scenario 1: using wireless routers. This is the simplest method, but the premise is that the laptop should have a wireless network card module, otherwise it will have to be wired only. The wireless router set is very simple, with the D-Link 624+A as an example, only need to open the input and 192.168.0.1 can enter the router interface in the browser, according to different needs, you can choose PPPoE (dial-up), Static IP (fixed IP) etc.. Details of the operation can be explained by instructions on the use of the router. D-Link 624+A router Take the D-Link 624+A router as an example of the settings page Scheme 2: if it is to go out, take the number of wireless router was not convenient, the hotel, school dormitories and other places have a 100Mbps network connection port, so in general only a computer can access the network. But now most of the notebook computer has a wireless network card, so you can make them a laptop computer through the wired access network, then the other computer connected together through a wireless network card, this can be achieved at the same time on the internet. There is no built-in wireless network card, you can also use USB, PCMICA interface wireless card to achieve. Usually, hotel, school dormitory cable network is automatically assigned IP address by DHCP, in this case, the two notebook computer case (notebook A and B), using dual wireless + antithetical couplet bridging way of Internet, the notebook