on precipitation in tube well pit construction（在管井降水井施工）.docVIP

On precipitation in tube well pit Construction Abstract: The high water table areas in the basic construction, dewatering, construction of infrastructure to provide a dry working environment is the key. This paper describes the precipitation tube well-based technology in the construction of a project application. Keywords: excavation, tube wells, precipitation 1 Project Overview and geological conditions A major project for the clay soil excavation, excavation slope of 1:3, according to the construction site above the actual situation, not to slope excavation shoring. Pit excavation to lower the key for the drainage, open digging, should reduce the water table to below the excavation surface 0.5m, non-disturbance natural foundation, reserve pit at the bottom 30cm thickness of the protective layer. foundation pit drainage ditches and tube wells mainly precipitation. Engineering Geology is divided into the lower three layers: the upper part of the artificial accumulation of fill-based, central part of the wavy red clay brick, the lower part of the bedrock to sandy conglomerate based. 2 Materials and equipment investment plans Well pipe: The concrete tube wells, well pipe diameter φ300mm, wall thickness of 50mm, the lower part of the precipitation for the 1.0m tube, the upper filter for the non-sand concrete pipe. Pumps: 2 sets of drainage ditches with mud 22kW, each deep wells within the configuration 1 sets 150QJ20-26 / 4 type deep well pump, a control switch for each pump configuration. 3 foundation pit construction ideas 3.1 General construction methods Excavation slope of 1:3, water content of soil material at this stage is moderate, the excavation pit directly in the second phase of excavation at 52.0m elevation using the following drainage ditches and the drainage tube wells, the second stage, from 52.0m The following elevation 52.0m height before excavation started to play deep in the cutoff wall construction of t