冲压模具基础知识--术语简介（Basic knowledge of stamping die -- Terminology introduction）.docVIP

冲压模具基础知识--术语简介（Basic knowledge of stamping die -- Terminology introduction） Basic knowledge of stamping die - term introduction Blanking Die blanking is to use some of the material or process conditions and other materials, (order) of a stamping process or pieces of waste separation. Blanking is cut, blanking, punching, punching, breaking, cutting, cutting, cutting edge cutting, cutting tongue, incision and trimming process. incision Open is a stamping process material along the open contour local rather than completely separated. Is cut apart or basic material is located in the front of in plane separation. Cutting edge Cutting edge trimming die forming process is the use of the edge of the piece, a stamping process to have a certain height or diameter, shape. Cut the tongue Cut the tongue is a stamping process material along the open contour local rather than completely separated. Is the local separation materials, has a certain position of the workpiece required, no longer in the front of the plane separation. cut off Cut is the material along a stamping process open contour separation, the separated materials become the workpiece or process. Flaring The flaring is hollow or tubular member of a stamping process open outward. punching Punch will be waste from the material or separation process on a stamping process along the closed contour in to obtain the mesoporous materials or process conditions on. Piercing Is the lack of punching waste materials or processes from the isolated part of a stamping process along the open contour, open the outline of the formation of gap, its depth is less than the width. Notching Punching is the waste materials or processes from the isolated part of a stamping process along the open contour, open contour is in a groove shape, its depth over width. Punching center hole At the center hole in a stamping process form a shallow concave hole in the center of workpiece surface, the back material does not have the corresponding projectio