变压器知识（Transformer knowledge）.docVIP

变压器知识（Transformer knowledge） I want to make a 220 12v100w annular transformer. There is now a 35mm diameter 70mm diameter high 48mm core. 220V wire diameter 0.44770 turns 12V wire diameter 1.9043 turns Core area (7.0-3.5 = 2*4.8=8.4). 220V current =100 / 220=0.45A wire diameter =0.65 * V 0.45 = 0.44 12V current =100 / 12=8.3 wire diameter =0.65 * V 8.3 = 1.7 Turn / V =45 / 8.4 / 1.5 = 3.5 220V turns =220*3.5=770 12V turns =12*3.5*1.02 = 43 For the ring transformer winding parameters There is a pressure regulator removed from the iron hand. The tin is white, the whole piece of joint. Core diameter 98mm, diameter 42mm, high 57mm. Want to change around the ring, primary 220V, secondary double 25V to 27V can be. The master can help calculate power can do much, what is the size of primary line, what is the number of turns. Core section: S = /2 (9.84.2) * 5.7 = 16 (c m) The number of turns per volt (10000 core permeability Gauss): N = 45/S = 45/16 = 2.8 (turn) The number of turns of the primary 220V: N1 = 220 * 2.8 = 616 (turn) 25V (secondary double turns on a single 25V calculation, the bifilar double (25V): compensation for iron and copper loss shall be increased by 5% turns) N2 = 25 x 2.8 x 1.05 = 74 (turn) Because there is no power line transformer is given, there is no data size calculation. Ask the best power to do more than 200, the ring core with smaller diameter, the maximum can do much to tile. The ring core permeability is not clear, from the regulator on the The maximum power (P = S/1.25) = square square (16/1.25) = 160 (W) The primary and secondary current: I1 = P/U = 160/220 = 0.73 (A) I2 = 160/25 * 2 = 3.2 (A) The primary and secondary line diameter (current density 2.5A): D1 = 1.13 * sqrt (I/ delta) = 1.13 * sqrt (0.73/2.5) = 0.61 (mm) D2 = 1.13 * sqrt (3.2/2.5) = 1.28 (mm) 220V transformer primary voltage, secondary voltage 12V, power 100W, for the primary and secondary winding turns and wire diameter. The selection of the transformer core cross-sectional