内墙涂装指南（Guidelines for interior wall painting）.docVIP

内墙涂装指南（Guidelines for interior wall painting） Requirements of base material: The most basic requirement of painting surface for building coating is dry, firm and clean. Drying: cement metope maintenance for at least 1 months (winter 7 weeks) above, humidity is less than 6%, wood surface humidity is less than 10%, metope without seepage, no cracks and other structural problems. Solid powder: no loose, no loosening of the old wall paint. Clean: no oil, grease, mildew, algae, and other adhesive substances. The base material does not meet the requirements, will seriously affect the film properties. The wall humidity, may cause paint blistering, peeling, peeling and surface infiltration, film culture base first light until the mold base material; loose dirt adhesion will affect the adhesion of the paint, cause skin peeling and other phenomena, such as mildew, to cause mildew paint. Two. Substrate treatment: A, the new wall maintenance: more than 1 months. The humidity is lower than 6% (can use hygrometer, remove dirt and stains test) exudation of alkali. B, the old wall: algae, high-pressure water washing or mechanical grinding to remove dust and may breed dry cleaning, it is necessary to brush mold solution (usable bleaching powder is prepared into 10% solution), then rinse with water; the old coating is good clean surface directly after the heavy: the old coating powder, cracking, blistering, peeling, to remove the old film after re brushing again two times paint primer. C, wallpaper wall: you can tear off wallpaper, wash away the glue, after drying, according to the wall conditions for proper treatment, and then construction. D, glass fiber surface: can be brushed directly coated finish. E, forest: surface to remove or replace worn and decayed parts, cleaning repair surface, should use the elastic windows and wall joint Good padding. F, metal surface: The 1. type of iron: should first remove the surface rust, to clean up immediately after brushing the rust primer. 2.