质量专题交底（Quality disclosure）.docVIP

质量专题交底（Quality disclosure） Quality disclosure The supervision personnel in the construction process of some quality problems in the inspection and examination, although the site after we try to correct, but waste a lot of energy, resulting in unnecessary work, the relevant matters needing attention and the quality problems to communicate with you now: First, steel sub item (production, installation): 1., due to the reasons for steel reinforcement, the surface is stained with sludge, and some of the root column tendons in pouring concrete when the floating slurry did not clear in time; Stirrups and column beam reinforcement 2. forming are neatly stacked, but there is still a phenomenon in the collection is not timely binding, failed to timely collection of the reinforced mud etc.; The bending starting point of the 3. beam and column reinforcement should be greater than the welding point 10d; 4. when setting out the beam reinforcement, the length of the beam should meet the requirements of design and construction acceptance. 5. rebar in connection with different common problems, in the construction process to avoid, especially to control all kinds of connection method parameters; 6. the anchor length and lap length shall not be lower than the design requirements and related atlas; 7., the anchor form to meet the requirements, the plate and the negative bending of the tendons on the hook should be placed in the correct direction, the upper negative curved hook down, bending hook can not lie flat, in concrete pouring, if there is stampede phenomenon, should be corrected in a timely manner; 8. in beam reinforcement, duck hanger and hanger bar binding, must be secured to prevent displacement in vibration; The transverse spacing of 9. beam bars is greater than the same rib diameter, and should not be less than 25 mm, column, beam main reinforcement lashing angle of main reinforcement in place, four important posts to stirrup angle, middle bar and stirrup close to and be bi