cad实用技巧（CAD practical skills）.docVIP

cad实用技巧（CAD practical skills） [CTrl+N] solution to invalid As everyone knows, CTRL+N is a new command But sometimes, CTRL+N appears the selection panel At this point, just set the settings in the OP option Operate: OP (options) - System - - there is a start on the right (A display, start dialog, B does not display the start dialog) When you select A, the new command is valid, and the reverse is invalid [Ctrl key invalid solution] Sometimes we have problems like this For example, CTRL+C (copy), CTRL+V (paste), CTRL+A (Quan Xuan) and a series of commands related to the CTRL key will Invalid At this point, you just need to tune in to the OP option Operation: OP (option) - user system configuration WINDOWS standard accelerator (tick) WINDOWS standard accelerator tick, and CTRL key commands is effective, and failure [solution to invalid selection] The correct setting for AD should be to continuously select multiple objects But sometimes, the continuous selection of objects will be invalid, you can only select the last selected object This can be resolved as follows Enter the OP (optional) - select the SHIFT button added to the choice set (to remove the hook) Add the SHIFT key to the selection, and then add select after remove the tick On the contrary, the selection is invalid Command: PICKADD value: 0/1. [CAD] ordered three reduction If the system variables in CAD are unintentionally changed Or some parameters have been deliberately adjusted, what should I do? At this time, there is no need to reinstall, nor do you need one change at a time Operate: OP option - configuration Reset Can resume But after recovery, some options also need some adjustments, such as cross cursor size, etc. ~! [mouse middle key is not good, how to do]? Under normal circumstances CADs rollers can be used to zoom in and out, and to shift (press and hold) But sometimes, when you press and hold the wheel, its not the translation, but the next menu. Its annoying At this point you can only tune the s