工厂变电所配电系统及设计.docVIP

河北理工大学轻工学院 QINGGONG COLLEGE, HEBEI UNITED UNIVERSITY 毕业设计说明书 设计题目：工厂变电所配电系统及设计 学生姓名：王晓川 学 号： 专业班级： 学 部：信息科学与技术部 指导教师： 2010年06月15日 摘 要 该工厂车间用电设备均为二级负荷。要求不间断供配电，停电时间过长将会造成产品报废，主要设备损坏。所以采用双电源引入该厂：从距该厂1.5 KM处引入一路10 KV电压等级电源C和从该1 KM处引入一路10KV电压等级电源D。 为确保全厂供配电的安全、Abstract The acreage of the construction is not very big ,the factory has many workshops and the load of each workshop is relative centralism, the distance of transmission is short .The main workshops and the appurtenance is two kind of loads. This factory requires uninterrupted power supply,once the power off time of the factory is long , the productions will be scrapped and the main equipments will be broken down.so this design uses double power sources to introduce this enterprise: C is from it’s 1.5km place an introduction group 10 KV voltage rank power source and D is from it’s 1km place an introduction group 10KV voltage rank power source. For firmly preserves the factory power supply is security, reliable, high quality and economy, therefore the design uses a total relief substation and two independent workshop substations, power C assume to the first workshop , power D substations assume to the second workshop. 、Considering the development of the factory, this design has obligated the location for the development in the substations. In transformer substation the circuit breaker all use the few oil indoors high pressure circuit breaker. The high-pressured circuit breaker uses the electromagnetism to hold the drive mechanism. The reactive power compensates selects the low pressure centralism automatic compensation method, the low pressure system uses the TN—C—S system. Key words: for the power distribution，the load computation，the transformer，the reactive power compensates，circuit breaker，relay protection 目录 I Abstract II 0绪论 1 1 设计要求和概述 2 1.1 工程设计概述 2 1.2 计算范围 2 1.3 设计步骤 2 1.4 设计结果 3 2 设计原始资料和设计依据 4 2.1 全厂用电设备负荷情况 4 2.2 电源情况 4 2.3 设计依据 4 3 电源及主接线方案选择 6 3.1电源选择方案介绍 6 3.1.1电源选择方案 6