fiber bragg grating sensor to monitor stress kinetics in drying process of commercial latex paints光纤布拉格光栅传感器监测应力动力学商业乳胶涂料的干燥过程.pdfVIP

Sensors 2010, 10, 4761-4776; doi:10.3390/s100504761 OPEN ACCESS sensors ISSN 1424-8220 /journal/sensors Article Fiber Bragg Grating Sensor to Monitor Stress Kinetics in Drying Process of Commercial Latex Paints Ivo de Lourenço, Jr., Gustavo R. C. Possetti, Marcia Muller and José L. Fabris * Programa de Pós-Graduação em Engenharia Elétrica e Informática Industrial, Universidade Tecnológica Federal do Paraná, 80930-901 Curitiba, Brazil; E-Mails: lourenco@.br (I.L.J.); gustavo_possetti@.br (G.R.C.P.); mmuller@.br (M.M.) * Author to whom correspondence should be addressed; E-Mail: fabris@.br; Tel.: +55-4133104642; Fax: +55-4133104683. Received: 3 February 2010; in revised form: 25 April 2010 / Accepted: 28 April 2010 / Published: 11 May 2010 Abstract: In this paper, we report a study about the application of packaged fiber Bragg gratings used as strain sensors to monitor the stress kinetics during the drying process of commercial latex paints. Three stages of drying with distinct mechanical deformation and temporal behaviors were identified for the samples, with mechanical deformation from 15 m to 21 m in the longitudinal film dimension on time intervals from 370 to 600 minutes. Drying time tests based on human sense technique described by the Brazilian Technical Standards NBR 9558 were also done. The results obtained shows that human sense technique has a limited perception of the drying process and that the optical measurement system proposed ca