TUE除锈涂装原则工艺.doc

江苏东方造船有限公司 除锈涂装原则工艺 第 2 页 共25页 List目录 Painting procedure chart…………………………………………………………………3 涂装流程图 General…………………………………………………………………………………….4 总则 Primary surface treatment……………………………………………………………….5 钢材预处理 To treat steel structure prior to derusting and coating…………………………………5 除锈涂装前的钢构件处理 Secondary surface treatment steel substrate prior to application of primer………….6 底漆涂装之前的钢材表面二次处理 Application of coating ……………………………………………………………….……8 涂装施工 Outfitting and galvanized pipes coating requirements..………………………………..11 舾装件及镀锌管的涂装要求 Quality requirements of derusting and coating ………………………………………..12 除锈涂装质量要求 Inspection and measurement of film thickness………………………………………… 15 膜厚的检验与测量 Paint list…………………………………………………………………………………...16 涂料列表 Painting specification…………………………………………………………………….. 17 涂装明细表 江苏东方造船有限公司 除锈涂装原则工艺 第 3 页 共25页 Painting procedure chart涂装流程图 Raw material 原材料 Primary surface preparation 表面预处理 Inorganic zinc silicate shop-primer which is TH-2 approx20 microns or CuiZhu type TH-2型或翠竹牌无机锌车间底漆约20μm Steel-cutting,prefabrication and assembling 钢材切割、预制、组装 Block assembly,pre-outfitting 分段组装、预舾装 Block secondary surface preparation 分段二次表面处理 Inspection,appilication of specified coatings 检验，涂装指定涂料 painting inspection,touch up 油漆检验、修补 Erection on berth, outfitting on slipway 船台合拢，船台舾装 Surface preparation to erection joint, tight seam area,outfits and damage area 合拢焊缝、密性焊缝、舾装件及损伤处等区域表面处理 Inspection,apply the same paint scheme as surrounding or specified coating 检验，涂与周围相同的涂料或指定的涂料 Painting inspection,touch up 油漆检验、修补 Launching,outfitting at pier下水、码头舾装 Surface preparation to outfits,damage area and remaining area 舾装件、损伤区域及剩余区域表面处理 Inspection,apply the specified coating检验，涂装指定涂料 Painting inspection, touch-up and close tanks 油漆检验、修补及封舱 In drydock,cleaning and treatment the whole shell and apply the subsequent paints 进坞，清理船壳外表，涂装完剩余涂料 Cleaning and treatment before delivery交船前清洁或处理 江