strain measurements within fibreboard. part iii analyzing the process zone at the crack tip of medium density fiberboards (mdf) double cantilever i-beam specimens在纤维板应变测量。.pdfVIP

Materials 2012, 5, 2190-2204; doi:10.3390/ma5112190 OPEN ACCESS materials ISSN 1996-1944 /journal/materials Article Strain Measurements within Fibreboard. Part III: Analyzing the Process Zone at the Crack Tip of Medium Density Fiberboards (MDF) Double Cantilever I-Beam Specimens Jörn Rathke 1,2,*, Ulrich Müller 1,2, Johannes Konnerth 2 and Gerhard Sinn 3 1 Wood K plus—Competence Centre for Wood Composites and Wood Chemistry, Altenberger Straße 69, Linz 4040, Austria; E-Mail: ulrich.mueller@kplus-wood.at 2 Department of Material Sciences and Process Engineering, Institute of Wood Technology and Renewable Resources, BOKU—University of Natural Resources and Life Sciences, Konrad Lorenzstraße 24, Tulln an der Donau 3430, Austria; E-Mail: johannes.konnerth@boku.ac.at 3 Department of Material Sciences and Process Engineering, Institute of Physics and Material Science, BOKU—University of Natural Resources and Life Sciences, Peter Jordan Straße 82, Vienna 1190, Austria; E-Mail: gerhard.sinn@boku.ac.at * Author to whom correspondence should be addressed; E-Mail: j.rathke@kplus-wood.at; Tel.: +43-(0)1-47654-4289; Fax: +43-(0)1-47654-4295. Received: 13 September 2012; in revised form: 15 October 2012 / Accepted: 29 October 2012 / Published: 7 November 2012 Abstract: This paper is the third part of a study dealing with the mechanical and fracture mechanical characterization of Medium Density Fiberboards (MDF). In the first part, an analysis of internal bond strength testing was performed and in the second part MDF was analyzed by means of t