施工工艺标中（Construction process standard）.docVIP

施工工艺标中（Construction process standard） Ordinary lamps and lanterns installation engineering construction craft standard 1 scope of application The utility model is suitable for installation of indoor and outdoor common electric lighting lamps and lanterns. Not suitable for special places, such as mines, ships, operation room and other places of electricity Installation of pneumatic lighting fixtures. 2 citation criteria Code for acceptance of construction quality of Building Electrical Engineering (GB50303-2002) General Atlas of building electrical appliances (92DQ-6) Construction and installation of sub engineering construction process specification fourth fascicle (DBJ 01-26-96) 3 construction preparation 3.1 equipment and material requirements 3.1.1 lamps and lanterns model, specification must comply with the design requirements and national standards. All lamps should have CCC certification and product qualification certificate. The shape and lamp holder of the 3.1.2 luminaire shall comply with the following requirements: 3.1.2.1 lamps and lanterns and fittings are complete, without mechanical damage, deformation, coating peeling, lampshade rupture, light box crooked and so on; 3.1.2.2 in addition to open type lamps and lanterns, other types of lamps, light bulb capacity of 100W or more, use porcelain lamp holder; The insulating housing of the 3.1.2.3 lamp cap is not damaged and leakage; the lamp holder with switch; the switch handle has no exposed metal part. The voltage level of the wire used by 3.1.3 lighting fixtures shall not be lower than AC 500V, and the minimum core cross section shall meet the requirements of table 1. 3.1.4 carries on spot random sampling inspection of the insulation resistance and internal wiring performance of the complete set of lamps and lanterns. The quantity is controlled at about 10% lamps The insulation resistance value is not less than 10 (2) M Omega, the internal connection is copper core insulated wire, and the core wire cross