板配筋要求（Plate reinforcement requirement）.docVIP

板配筋要求（Plate reinforcement requirement） Reinforced concrete beams and plates are typical flexural members of buildings. According to the bending situation of the plate, it can be divided into one-way plate and two-way plate. The beam (plate) can be divided into Jian Zhiliang (plate) and multi span continuous beam (plate) according to the supporting situation. Force characteristics of 1. one-way and two-way slabs The plate supported by two sides is one-way plate, one direction is bent, and the two-way plate is supported by four sides, and the two-way bending is made. If both sides supported plate cloth, when the long and short side is less than or equal to 2, according to the calculation of two-way slab; when the long and short side is greater than 2 but less than 3, are advised by two-way slab calculation; when pressing the unidirectional plate along the short side direction force calculation, along the long side direction of structural reinforcement enough; when the long and short side length is greater than or equal to 3, according to the one-way plate along the short side direction force calculation. 2. stress characteristics of continuous beam (slab) The slab, secondary beam and main beam in the cast-in-place ribbed floor are usually multi span continuous beams (slabs). The internal force calculation of the continuous beam (plate) is the main content, and the reinforcement calculation is the same as that of the simple beam. The stress characteristics of continuous beam and plate are that there is a positive bending moment in the midspan and a negative bending moment at the support. Therefore, the vertical reinforcement is calculated at the maximum positive moment in the midspan, and the negative ribs are calculated at the maximum negative moment. The cut-off position of the steel bar shall be cut off according to specifications. (two) reinforcement requirements of reinforced concrete slabs The thickness of the plate is related to the span of the calculation. The