模具维修（Die maintenance）.docVIP

模具维修（Die maintenance） Must be regularly maintained and replaced, otherwise it will cause damage to the mold or production is not smooth 4. adjustment of mould clearance The core positioning hole due to frequent, many of the core combination caused by abrasion, after assembly clearance is too large (loose or assembled) uneven gap (positioning deviation), can cause the cutting profile variation, punch is easily broken, burrs, through the check section of punching after adjusting the gap. Hours gap section is less, the large gap, cross section and more flash is larger, with a shift to get in the way of reasonable gap, after adjustment, should be properly recorded, also can be used as a mark in the die edge, so that subsequent maintenance work. Daily production should pay attention to collecting and retaining the original material when the mold is in better condition, such as the subsequent production is not smooth or the mold changes, can be used as a reference for mold maintenance. In addition, if the auxiliary system such as the top pin is worn out, whether the material can be raised and whether the guide pin and Bush have been worn out shall be inspected and maintained Two. Causes of common failures of dies and Countermeasures In the production of Stamping Progressive Die, stamping for bad phenomenon must make a concrete analysis, take effective countermeasures, solve the problem that may happen fundamentally, so as to reduce the production cost, to achieve smooth production. The following is the production of common stamping bad phenomenon, its causes and treatment countermeasures are analyzed as follows, for the mold maintenance personnel reference. 1. pieces of burrs (1) reason: A, knife edge wear; B, gap is too large, the effect is not obvious after training, C, knife edge broken angle; D, gap unreasonable upward and downward offset or loose; E, mold dislocation up and down. (2) measures: A, B, the knife edge; machining precision control punch or modify the desi