模具设计（mould design）.docVIP

模具设计（mould design） Chapter 1 description of the product The utility model has the advantages of simple structure and simple structure of the mould frame. The material is polypropylene, molding properties are general, others have no special requirements. The second chapter is the analysis of plastic parts Chemical name: polypropylene (PP) Material analysis: the material of the plastic parts is polypropylene, which belongs to the plastic. From the performance point of view, the plastic has good rigidity, water resistance, heat resistance, dielectric properties and temperature and frequency independent and other advantages, is the ideal insulation material; the forming properties, water absorption properties of the plastic melt flow, performance good, easy molding, but large shrinkage. In addition, when the plastic is formed, it is easy to produce shrinkage, dent, deformation and other defects. When the molding temperature is low, the direction is obvious, the solidification speed is faster, and the internal stress is easy to occur. Therefore, in molding, attention should be paid to control molding temperature, the casting system should be relatively slow heat dissipation, cooling speed should not be too fast. Determination of plastic injection molding process parameters: according to the structural features and formability of the plastic parts, consult the relevant manual to obtain the polypropylene forming process parameters: Injection molding process parameters of plastic parts Process parameters, contents, process parameters, contents Preheat and dry temperature 80~90 degrees Molding time /s, injection time 0~5 Time 0.5h holding time 20~60 Barrel temperature / temperature Front 180~200 cooldown 15~50 Middle section 200~220 total cycle 35~115 Back section 160~170 screw speed / (r/min) 30~60 Nozzle temperature / C 170~190 After treatment method, room temperature air cooling Mold temperature / temperature 20~60 / 20~30 Injection pressure /MPa 70~120 time /h 1~2 The th