一种深部矿井中微震源的二次定位方法.pdfVIP

Trans. Nonferrous Met. Soc. China 26(2016) 2988−2996 Relocation method of microseismic source in deep mines 1,2 1 1 3 1 Lin-qi HUANG , Xi-bing LI , Long-jun DONG , Chu-xuan ZHANG , Dong LIU 1. School of Resources and Safety Engineering, Central South University, Changsha 410083, China; 2. School of Civil and Mechanical Engineering, Curtin University, Perth 6102, Australia; 3. Nuclear Resource Engineering College, University of South China, Hengyang 421000, China Received 22 September 2015; accepted 1 September 2016 Abstract: A new method, named relocation, was proposed to reduce the impact of sensor errors systematically, especially when available data of sensors are abundant. The procedure includes evaluating the reliability of every sensors datum, processing the initial location by the credible data, and selecting a set of equations with optimal noise tolerance according to the relative relationship between the initial location and sensors location, then calculating the final location by k-mean voting. The results obtained in this research include comparing traditional location method with the presented method in both simulation and field experiment. In the field experiment, the location error of relocation method reduced 41.8% compared with traditional location method. The results suggested that relocation method can improve the fault-tolerant performance significantly. Key words: micro-seism; relocation; k-mean; equation selection; sensor array failure and recorded by sensors), analyzing