风淬转炉渣作为喷砂磨料的可行性及效果研究-表面技术.pdfVIP

第43卷摇 第2期 摇 摇 摇 表面技术 摇 摇 2014年04月 SURFACE TECHNOLOGY ·49 · 試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試試 风淬转炉渣作为喷砂磨料的可行性及效果研究 1 1 1 2 钟鹏 ,周俐 ,常立忠 ,丁陈来 (1.安徽工业大学,安徽 马鞍山243002;2.马钢股份有限公司技术中心,安徽 马鞍山243003) 摘摇 要: 目的摇 实现风淬转炉渣的再利用,论证风淬转炉渣作为喷砂磨料的可行性及应用效果。 方法 对比风淬渣和韩国PS球、铜炉渣等磨料在成分、微观结构、物化参数以及抗破碎性方面的异同,并以风淬 渣作为磨料对工件进行喷砂处理,检验处理效果。 结果摇 风淬渣具备磨料的特性,一次破碎回收率可达 70%,用风淬渣作为磨料处理的工件,清洁度可以达到Sa2.5级,表面粗糙度可达到粗级以上。 结论摇 将 风淬渣作为磨料,能够满足工业清理和涂装需求,实现钢渣资源的有效利用。 关键词:风淬转炉渣;喷砂;磨料 中图分类号:TQ639.1摇 摇 摇 文献标识码:A摇 摇 摇 文章编号:1001鄄3660(2014)02鄄0049鄄06 Feasibility and Application Effect Research of the Wind Quenching Slag as Sand Blasting Abrasive 1 1 1 2 ZHONGPeng ,ZHOULi ,CHANGLi鄄zhong ,DING Chen鄄lai (1.Anhui University of Technology,Ma忆anshan243002,China; 2.Technology Center,Masteel Co. ,Ltd,Ma忆anshan243003,China) ABSTRACT:Objective To reuse wind quenching slag,and demonstrate the feasibility and application effect of wind quenching slag as abrasive. Methods The similarities and differences in composition,microstructure,physical and chemical parameters, crush resistance of wind quenching slag and South Korea PS ball,copper slag,etc,were analyzed. At the same time,the wind quenching slag was used as abrasive blasting,and the effect of treatment was studied. Results The wind quenching slag has the characteristics of the abrasive,and the broken recovery of steel slag can reach70%. Artifacts cleanliness levels of the processed workpiece by wind quenching slag can achieve Sa2.5,roughnessreachesaboveroughlevel. ConclusionThepro