加工小尺寸内螺纹常出现的问题及解决办（Problems and solutions to the machining of small sized internal threads）.docVIP

加工小尺寸内螺纹常出现的问题及解决办（Problems and solutions to the machining of small sized internal threads） The manufacturing unit of a machine is a part, and parts are connected together in a certain form to form a machine. Thread connection is one of the connection forms among the parts, so thread is often one of the most common parts. The commonly used methods of machining thread are car, tapping, rolling and so on, and tapping thread is the most widely used method of internal thread processing. Especially for small size internal threads, tapping is almost the only method of machining. There are two methods of tapping thread, that is, hand attack and machine attack. In order to facilitate thread processing, the following problems are pointed out in the thread processing, such as the usual problems, causes, solutions, and common methods of removing broken taps. 1 tapping threads with ordinary tap and matters needing attention 1) hand tapping thread method and matters needing attention At present, hand tapping thread still occupies a certain position in machining. Because in actual production, some threaded holes are not suitable for machine tapping threads due to the location or the shape of the parts. For small thread, because the thread diameter is smaller, the tap strength is lower, the machine tapping thread is easy to break the tap, usually also use hand tapping thread. However, the quality of hand tapping thread is greatly affected by human factors, so we can only guarantee the quality of hand tapping thread when we adopt proper tapping method. The workpieces installation folder A. machining workpiece clamping to it. Under normal circumstances, the workpiece should be tapped at the horizontal or vertical position. It is easy to judge and keep the tap perpendicular to the surface of the workpiece. The initial position of the B. tap is that when the tap starts, the tap should be placed straight, and then one hand righting the tap, and the other hand gently turns the hinge bar