插座接法（Socket connection）.docVIP

插座接法（Socket connection） The switch line switch must be installed on the front line, pay attention to polar socket wiring, sockets should be left in the face of positive, zero line, right on the line, line, polar electric wire connected to a written examination, must pull the wiring, remember!!!!!! How to use a multimeter instead of measuring the pencil FireWire posts are viewed 1020 times | reply 11 times When we want to measure the power supply line is connected, but did not have a test pencil when only a multimeter can complete the test. First of all, we should understand the principle of pencil. Pencil by metal rod, neon, carbon resistor and metal cap. A neon bulb is a device that glows, a glass ball filled with inert gas, and a voltage of carbon resistance in 1M or above. The metal cap is the part of the hand contact. When people and metal cap contact, FireWire, pencil, body and earth to form a loop, which is about 100pF and the capacitance between any of the earth, this is a loop. When using multimeter, whether digital or pointer type multimeter, after understanding the general range of supply voltage, we take 220VAC voltage as an example. The multimeter block adjustment to the 400VAC file, the red pen is inserted into the line of fire, touch the black pen, then multimeter if the readings showed that this line has been connected. This method does not cause any danger to human reason is: digital multimeter resistance 10M in Europe, the European /V 20K internal pointer table, if the measured voltage of 220V, the resistance is 20K x pointer table 220V=4400 Europe, absolutely safe, because the resistance of carbon pencil is commonly used in Europe 1M. According to the above method, when we need to measure whether FireWire connected, but no pencil case, use a multimeter to any form. Home improvement will certainly use the air switch, but not everyone knows how to buy air switches, and now about the introduction, so that we have an understanding. The first said the p