除法器设计.doc

除法器设计 摘要: 本设计要求设计一个简单的除法器,根据要求采用乘法器BG314与运算放大器3554AM以及外部电源共同实现除法器功能.乘法器用以实现乘法运算,然后通过运算放大器工作于负反馈状态实现信号的放大,并由自制电源电路供电.通过对系统各模块进行仔细的分析,了解了各器件的性能与用途后,便可将其运用到自己的设计当中去.电路设计完成后,开始对系统进行测试,方法有两种,可以通过对系统电路在Multisim软件下仿真测试,也可以做出相应的印制电路板来进行测试.在本设计中,通过仿真测试与实物测试相结合的综合测试后,发现系统基本能达到设计要求. 关键字: 乘法器 运算放大器 电源 Multisim 印制电路板 Summary: This design requests to design a simple division machine, adopting the multiplication machine BG314 and the operation enlarger 3554 AMses and the exterior power supplies according to the request to carry out the division machine function together.The multiplication machine carries out the multiplication operation in order to, then pass to operate the enlarger work to carry out the signal to enlarge in the negative feedback appearance, and from the self-control power supply electric circuit power supply.Pass to carry on the careful analysis to each mold of system piece, after understanding the function and uses of each machine piece, can make use of it to own design then in the middle.The electric circuit is after design complete, starting carrying on the test to the system, the method have two kinds of, can pass to imitate the true test to the system electric circuit under the software of Multisim, can also do a homologous of print and make circuit board to carry on the test.In this design, after passing to imitate the comprehensive test that the true test and real objects test combine together, discover that the system is basic and can attain design to request. Key word: The multiplication machine operation enlarger power supply Multisim prints to make the circuit board 目 录 1、系统方案设计与论证 ……………………………………….1 1.1 设计要求 …………………………………………………………….1 1.2 系统基本方案 ……………………………………………………..1 1.2.1 各模块方案选择与论证 ……………………………………………..1 (1) 乘法器模块 ………………………………………………………..1 (2) 运算电路模块……..………………………………………………….2 (3) 电源模块 ……..………………………………………………….2 (4) 显示模块 ……..………………………………………………….2 1.2.2系统各模块的最终方案 ………………………………………3 2、系统的硬件设计与实现 ……………………………