汽车工艺（Automobile technology）.docVIP

汽车工艺（Automobile technology） Automobile assembly and debugging process I. judgment 1, the accelerated drawing arrangement, the direction should be smooth, there may be forced bending or fixed phenomenon * 2, radiator pipe, water pipe should be no bending deflated, pipe joints shall be Water Leakage tick infiltration 3, the maximum load quality of the car is the largest freight quality * 4, the car pulled away, the gasoline engine is a mixture of air and fuel gas, diesel engine into the air B. 5, the transmission effect: the engine output power is transmitted to the drive wheels, and to meet the need of driving conditions, change the size of the torque, in order to ensure the normal operation of the vehicle B. 6 the fuel line must not be bundled with the electrical wiring harness. B. 7, in the absence of tire tightening machine, you can use pneumatic wrench instead of tightening * In 8, filling brake fluid before the first vacuum B. 9, the front beam value measurement can not be adjusted, only x 10, the bolt assembly, as long as the matter on the line, no matter what tools will take * 11, the average fuel consumption refers to the car in no-load condition, in the road when the fuel consumption * 12, in the tire specifications, the letter D means the nominal diameter of the tire, and B means the thickness of the tire * 13, the engine five big systems refer to the fuel system, the lubrication system, the cooling system, the start system, the transmission system (gasoline engine special-purpose) * 14, the safety belt is through the webbing restraint occupant exercise with high intensity, reduce or avoid the occupant and other objects collision damage tick 15, in the automobile assembly, fuel, coolant belongs to the auxiliary material B. 16, the first stage of the construction of the factory is to carry out feasibility studies * 17, automobile assembly plant generally includes: vehicle assembly, testing, commissioning, repair roads, Part V Civil engineering design 18, the