喷油器针阀偶件的研磨（Lapping of needle valve pairs of injector）.docVIP

喷油器针阀偶件的研磨（Lapping of needle valve pairs of injector） Lapping of injector needle valve pairs 0 Management is the core of injector needle valve (commonly known as oil head), its working status directly affects the economy and reliability of the diesel engine, part of the grinding head oil engineer miss the point especially for BW, MAN and BW non cold oil head more difficult. The author combines years of oil head grinding practice, the oil head grinding matters needing attention are arranged as follows, for beginners reference. First, enough patience The grinding of the oil head requires some skill, but the premise is patience. Little strokes fell great oaks., grinding head in the oil may be good. Oil head damage in a variety of forms, different forms of damage on the grinding method is not the same as oil head hard materials, abrasive for grinding fine grinding, it is time-consuming and laborious, some tend to test several times, in order to repair. So when grinding, effort must be good, if you do not have enough patience, anxious, often with, without success, will once again confirms the old saying, More haste, less speed. Two, clean Oil is the head of precision parts, and maintenance of other precision parts, grinding process and complex equipment must keep enough clean, otherwise not only grinding damage and failure, will speed up the oil head, a serious cause of oil head scrap. The seat is not clean, metal powder or particles will pull the sealing seal to ensure broadband, broadband; needle guiding parts (cylinder) by abrasive fouling, accelerated cylinder needle valve and valve seat contact surface wear, the oil leakage increases. Three, sand selection and coordination Marine grinding usually has three kinds: one is general grinding sand, used for grinding various copper valve, exhaust valve, steel valve and air compressor valve plate, the color is mostly gray, is a precision coupling universal grinding sand, the color is mostly green; there is a special grindin