木工（carpentry）.docVIP

木工（carpentry） I. construction requirements of (light gauge keel + gypsum board): 1. material selection: must use the snowflake light steel keel, the board surface does not have the design request, must take With 9 mm plasterboard. Ceiling maximum spacing shall not exceed 400mm * 600 mm. 2. fixed gypsum board of self tapping screw nut must be lower than the plate plane 1mm and painted antirust paint, nail distance is not Beyond 250mm. 3. bar = 2 x 2 cm diameter hanger, hanger spacing is 800mm - 900mm. 4. vertical steel keel in the transverse and light steel keel connections should be used to increase the lateral connection Load carrying strength of suspended ceiling. 5. gypsum board joint should be left 4 - 6mm, should be opened eight character seam, joints must be bandaged or cloth, Crack prevention. 6. hanging paste modeling part, large core board out of shape. 7. ceiling keel must use AK shaped expansion bolts fixed, expansion bolt spacing is less than or equal to 500mm. 8., Yang corner stitching must be large surface pressure small surface, the stitching seam to stay hidden. 9., the right corner of the plasterboard should be a whole set of cut, not spliced. 10. heavy duty lamps, fans and other equipment are strictly prohibited to be installed on the ceiling keel. 11. ceiling seam height difference of less than 1mm, the joint straightness is less than or equal to 3mm. 12. cover panel and the keel contact must be closely connected, no loose, smooth surface (roughness less than 1.5 mm), Obviously high and low steps, the seams are straight and uniform in width, and the texture is turbulent. Two, doors and windows construction requirements: 1. door: Daixinban base, posted outside the nine board with decorative panels, door hanging side with double core board as the base. The 2. window set, dumb: single core board with decorative panel base. Line thickness should be 12mm, The other side is greater than or equal to 5 mm (special design requirements except). 3. door fram