24cxx存储器（24cxx memory）.docVIP

24cxx存储器（24cxx memory） Or purchase a dedicated debug remote controller from the manufacturer and use the blank memory as described above. If we have repaired can enter D mode using the user remote controller according to the above method with the movement of TV, the best prepare a few blank 24C04 memory, using IC socket installed on the boot, write data after the exit, and make a mark, to prepare for the later maintenance to the user remote controller in D mode of the movement of color TV to purchase parts manufacturers, save trouble, improve maintenance efficiency. 3. Samsung PHILPS 12C TV + movement Leroy Samsung + PHILPS 12C movement refers to the CPU by KS88P8324N, the small signal processing chip OM8838PS core, by the movement of derived color TV representative models: RD21S, RK21B, R2169S and R2171S, in which E2PROM model is 24C08 or 24C16. CPU can also initialize data when it is replaced by blank memory, but it is not complete and some functions can not be realized. You must enter factory mode at this point. With the user remote control, remove the plastic film above. In the strong receiving button, the blank key is the factory mode button. Click on the button, the screen displays a red FACTORY\, O on the remote control to 7 number keys can be selected for O ~ 7 channels selection menu; according to the project, adjust the volume data according to the input data after subtraction, the factory again according to the factory mode key to exit. It is worth noting that the movement must be installed on the boot memory, or use the E2PROM substitute 24C02 capacity is too small, otherwise can not boot. Two, CPU and memory configuration and replacement notes The main part of Leroy TV CPU pin function and matched memory models shown in the table below. Please note the application after the table. 1: two kinds of CPU interchangeable, E2pROM can also use 24C01 or 24C02, but to change the circuit. 2. early Leroy TV the factory burned TMP87PS38N, later production of color