换热器热出温度和冷水流量串级控制(Heat exchanger temperature and cold water flow cascade control).docVIP

  • 6
  • 0
  • 约9.97千字
  • 约 13页
  • 2017-10-06 发布于河南
  • 举报

换热器热出温度和冷水流量串级控制(Heat exchanger temperature and cold water flow cascade control).doc

换热器热出温度和冷水流量串级控制(Heat exchanger temperature and cold water flow cascade control)

换热器热出温度和冷水流量串级控制(Heat exchanger temperature and cold water flow cascade control) Course design of process control instrument Title: heat exchanger temperature and cold water flow cascade control Student name: Class: Student number: Advisor: May 28, 2009 Catalog 1. introduction to the system:... 2. process requirements:... 3. flow chart:... 4. block diagram:...:... 5. meter selection:... 6. list of instrument models list:... I. brief introduction of the system: The design is a cascade control system with the cooling water flow rate and the hot water outlet temperature of the heat exchanger as the controlled quantity. The heat exchanger temperature and cold water flow cascade control structure is closed loop. It has temperature controller, flow controller, temperature sensor, flow sensor and controlled object. A temperature sensor and a flow sensor measure the controlled flow and convert it into a signal form that is easy to utilize, producing a deviation signal as compared with a given value. The deviation signal changes the temperature and flow of the measured point according to the direction of the elimination deviation by the temperature controller and the flow controller, and is adjusted to a given value of hope. Two. Process requirements: A water pump from the water tank in the V104 P101 routing for pressurized pressure head into the boiler through the heat exchanger X-102I, E-101 into the boiler when the boiler water, meet the experimental requirements, close QV-115, and open the valve QV-114, which makes the boiler water flow back to the pump P101 and the formation of hot water circulating pump; another route P102 V104 obtained from the tank pressure head, the formation of cold water circulating through a regulating valve FV-101, X-102II heat exchanger and V104 backflow into the water tank; the cold and hot water in the heat exchanger X-102 for heat exchange, the temperature of hot water flowing through the X-102I decreased, X-102II increased in the temperatur

您可能关注的文档

文档评论(0)

1亿VIP精品文档

相关文档