Polysius燃烧器基本原理和日常操作.ppt

Cooling air flap冷风挡板 Remote control远程控制 Starting burner 点火燃烧器 primary air fan 一次风机 valve train for natural gas/ oil 天然气/油的阀站 air duct for primary air 一次风管 燃烧器burner Necessary checks on burner system 燃烧器系统必要检查 Flame shape火焰形状（中控） Leaks on pipelines and hoses管道和软管渗漏检查（现场） Burner refractory燃烧器耐火材料 For inspetion works on primery air fan, cooling air fan, oil gun, ignition burner, flame monitors, valve train: see subsupplier manuals for details 关于一次风机、冷风机、油枪、点火燃烧器、火焰监测器、阀站的日常维护详见机械手册。 Maintenance of the POLFLAME VN燃烧器维护 Maintenance of the POLFLAME VN燃烧器维护 Refractory must be checked and replaced if necessary 必须检查耐火材料，如果有必要应更换 Maintenance of the POLFLAME VN: wear control Loosen the flange and check the marked interior surfaces. The worn should be touched up with Eurodur 松开法兰，检查内部表面磨损情况，如有需要应修复磨损部位。 Cracks in the burner tip disc Because of high heat stresses at the burner tip cracks can occur at individual places. But this will not impair the function of the burner. 由于燃烧器头部高热压可能导致两个喷嘴中间出现裂缝，但是不会影响燃烧器的功能和运行。 Safety on plant side设备周围的安全说明 The warnings must be observed 必须注意设备周围的安全警告 The protective clothing must be worn 必须穿戴保护服 The protective equipment must be worn 必须穿戴保护设施 The protective devices must not be removed during the operation 在运行的过程中不得将保护装置移走 The maintenance intervals must be adhered to 必须按照维护周期维护设备 Training Conch 2011 05. Dezember 2011 Alexander Michaelis 022-1 * S:\Template\Template.Pol.2010\PolysiusPraesentation.pot POLFLAME VN? Training CONCHDO 3 D000403 Alexander Michaelis– 022.1 – WUHU CONCH 05.12.2011 Content目录 Components of the main burner system主燃烧器组件 Design parameters of the POLFLAME VN燃烧器火焰设计参数 Structural design of POLFLAME VN燃烧器构造设计 Adjustment of the POLFLAME VN燃烧器调整 Structural design of burner carriage DRS 500A燃烧器小车构造设计 Alignement of the POLFLAME VN燃烧器找正 Starting of the POLFLAME VN燃烧器的开启 Maintenance of the POLFLAME VN 燃烧器维护 Safety on plant side设备周围安全说明 Components of the main burner system Kiln hood窑头罩 burner track燃烧器轨道 burner carriage燃烧器小车