人体支撑式吸尘器翻倒测试规范.docVIP

真空吸尘器翻倒测试 （人体支撑式） 修订 日期 修订 单号 修订内容摘要 页次 版次 修订 审核 批准 2011/03/30 / 系统文件新制定 2 A/0 / / / 批准： 审核： 编制： 真空吸尘器翻倒测试 （人体支撑式） 1.0 Purpose / 目的 To evaluate the safety of the body supported type sample when tipovered with container filled to maximum capacity 评估人体支撑式吸湿型样機在吸满水后在翻倒过程中是否符合UL1017安全要求 2.0 Definition/概念: None無. 3.0 Reference Documents/參考文獻: U.L.1017 CAN/CSA-C22.2 NO.243-01, dated 12-7-2001,CL5.12.6.2，5.12.6.4, 5.12.6.5 5.12.6.6 4.0 Equipment/設備: 4.1 Leakage Current Tester. 泄漏电流測試儀. 4.2 Leakage test switching box. 泄漏电流测试盒 4.3 Frequency Converter. 变频电源 4.4 Stop watch. 秒表 4.5 Withstanding Voltage Tester耐压测试仪 4.6 Test vessel测试容器 5.0 General Instructions/說明: 5.1 Tests may be conducted at any ambient temperature within a range of 10-40℃ (50-100℉). 測試可在10~40℃(50~100℉)之內的環境溫度下進行. 5.2 Unless otherwise noted, all tests are to be conducted with appliance connected to a 120VAC, 60Hz power source. 除非另外標注,否則所有样機都将连接在120V/60Hz電源下进行測試. 5.3 All equipment used must be calibrated on an annual basis. Calibration stickers with last calibration and calibration due date must be affixed to each instrument.. 使用的所有設備都必須以一年為周期進行調校.載有最後調校日期和調校周的調校粘紙必須被粘固在每個儀表上. 5.4 In this test, record leakage current according to the method noted in TAREGW1004. 本测试中，按照TAREGW1004所述记录测试前，中，后的泄漏电流. 5.5 For this test, the sample and vessel must be isolated from ground. 测试过程中，测试容器要与地绝缘. 6.0 Procedure/步驟: 6.1 Obtain a representative sample of the appliance to be tested. 準備一台有代表性的樣機用於測試 6.2 Obtain Test Results Form TTR1039 and completely fill in the information describing the sample and the equipment used prior to running the test. 用TTR1039測試結果的表格, 在測試運作前完整地填入樣機和使用的設備的情況. 6.3 Connect the sample, Leakage Current Tester Leakage testing switch box together per TAREGW1004. 按照TAREGW1004所述将样機，泄漏电流測