可充电型吸尘器电池排气测试规范.docVIP

真空吸尘器电池排气测试（可充电型） 修订 日期 修订 单号 修订内容摘要 页次 版次 修订 审核 批准 2011/03/30 / 系统文件新制定 2 A/0 / / / 批准： 审核： 编制： 真空吸尘器电池排气测试（可充电型） 1.0 Purpose / 目的 To evaluate the safety of battery pack employed in the rechargeable type sample when terminals of battery pack are short-circuited. 评估可充电型样机的电池是否符合安全要求. 2.0 Definition/概念: 2.1 Discharge-Operate the sample no longer to operate with the switch in the”on” position for an additional hour. 电池完全放电-运行样机直到其完全停止,再保持开关处在开的位置上多一个小时. 2.2 Recharge-Charge the discharged sample for 16 hours through the charger connected to a supply main of 120V/60Hz. 充电-让电池完全放电的样机通过充电器接上120V/60Hz电源充电16小时. 3.0 Reference Documents/参考文献: ULS-01017-DMLW-DataSheet-2001 Form Issued: 1992-07-01 Form Revised: 2006-07-07 4.0 Equipment/设备: 4.1 Frequency Converter. 变频电源 4.2 Nonconductive oil and test box. 绝缘油和测试容器 4.3 Digtal multimeter. 万用表 4.4 Knife switch 闸刀开辟 5.0 General Instructions/说明: 5.1 Tests may be conducted at any ambient temperature within a range of 10-40℃ (50-100℉). 测试可在10~40℃(50~100℉)之内的环境温度下进行. 5.2 Unless otherwise noted, all tests are to be conducted with appliance connected to a 120VAC, 60Hz power source. 除非另外标注, 否则所有样机都将连接在120V/60Hz电源下进行测试. 5.3 All equipment used must be calibrated on an annual basis. Calibration stickers with last calibration and calibration due date must be affixed to each instrument. 使用的所有设备都必须以一年为周期进行调校. 载有最后调校日期和调校周期的调校粘纸必须被粘固在每一个仪表上. 6.0 Procedure/步骤: 6.1 Obtain a representative sample of the appliance to be tested. 准备一台有代表性的样机用来测试. 6.2 Obtain Test Results Form TTR1033 and completely fill in the information describing the sample and the equipment used prior to running the test. 用TTR1033结果的表格, 在测试运作前完整地填入样机和使用的设备的情况. 6.3 Discharge and recharge the sample. 将样机电池完全放电后充满电. 6.4 Short-circuit the terminals of battery pack