用线爆喷涂技术改性玻璃表面的试验研究.pdfVIP

第33 卷 第2 期 高 电 压 技 术 Vol. 33 No. 2 2007 年 2 月 High Voltage Engineering Feb. 2007 ·199 · 用线爆喷涂技术改性玻璃表面的试验研究 杨家志，刘钟阳，许东卫 （大连理工大学电气工程与应用电子技术系，大连116024 ） 摘 要：为发展在玻璃表面的镀膜工艺，进行了应用线爆喷涂技术在玻璃管内表面制备导电铜膜的试验。结果表 明，在一定的放电电压范围内，该技术可在玻璃管内表面制造较均匀的涂层，涂层与玻璃管内表面的附着强度达 2. 632 Mpa ，SEM 电子显微观测发现，铜微粒已深入玻璃基体内，同时测得涂层厚度 400 ~ 500 !m ，电导率 18. 37 kS/ m ，玻璃管在喷涂前的工频耐压约40 kV ，喷涂后约为38 kV 。 关键词：线爆喷涂；玻璃；镀膜；表面改性；附着强度 中图分类号： TN304 文献标识码：A 文章编号：1003-6520 （2007 ）02-0199-03 Experimental Research of Glass Surface Modification Based on Wire Exploding Spray Coating Technology YANG Jiazhi ，LIU Zhongyang ，XU Dongwei （Department of Electrics Electronics Engineering ，Dalian University of Technology ， Dalian 116024 ，China ） Abstract ：In order to develop an electrical conducting film onto the dielectric substrate ，such as glass and ceramic ，to en- hance their surface performances ，the Wire Exploding Spray Coating （WESC ）method is applied to deposit a thick copper film onto the inner surface of a glass tube. The electrical diagram and the schematic diagram of the spray coating chamber is given. The film obtained by WESC method at the atmosphere pressure and room temperature is more uniform when a higher discharging voltage between the copper wire is used，which means more energy is deposited into the copper wire ，and the wire will be destructed more efficiently. But the glass tube will fall to pieces if the voltage is above 22 kV ，which will cause a strong shock wave ，and a 20 kV discharging voltage is applied in this paper. A series of tests have been done to the