专用垫片落料模设计和加工.docVIP

专用垫片落料模设计和加工 摘 要：本次设计为专用垫片的落料模设计。设计过程需要熟悉冲压工艺，了解冷冲压的过程。设计的重点思想是通过简单的单工序落料模的设计、绘制二维图、设计三维图，来让我们熟悉冲压模具的设计步骤，了解冲压的过程，对冲压工艺进行进一步的学习，同时也培养我们的独立思考能力。设计主要内容有：确定冲压方案、排料方式、模具类型，凸凹模和模具零部件的尺寸计算，模架和其零部件标准件的规格选取，确定模具装配方案，绘制模具中非标准件的和装配图的二维图，设计模具装配图的三维图，编写凸凹模和凸模固定板的工艺卡片，撰写毕业论文。最后成果有：毕业论文一篇；非标准件和装配图的二维图；装配图的三维图；工艺卡片。 关键词： Design and machining of special gasket blanking die Abstract：This design is for special gasket blanking die. I need to be familiar with sheet metal forming technology and cold stamping process in the design process. The focus of this design is through the simple single process of blanking die design, mapping the two-dimensional, three-dimensional design to make us be familiar with the stamping die design steps and understand the stamping process. It not only helps us make further study for the stamping process but also cultivate our independent thinking. The main content of this design includes: determine the stamping scheme, discharge way, die type, intensive and calculate the size of the mould parts; choose the standard for specifications of the formwork and its components parts; determine the mold assembly scheme; draw the two-dimensional diagram of standard parts,nonstandard parts and assembly drawings; design the three-dimensional diagram of assembly drawing of die; compiling operation cards of convex concave die and punch fixed plate; finish my graduation thesis. The final results are as follows: A paper of graduation thesis; Two-dimensional diagram of non standard parts and assembly drawings; Three-dimensional diagram of assembly drawing; Operation card. Keywords: Blanking die, Single process die, Stamping die, 3D chart, Operation card 目 录 1 绪论 1 1.1 课题背景 1 1.2 模具设计在国内外的发展情况 1 1.3 课题的相关工作 3 2 零件工艺的分析 4 2.1 工艺分析 4 2.2 工艺方案及模具结构型式的确定 4 3 工艺计算 5 3.1 排样设计 5 3.2 冲压力计算 6 3.3 确定模具中心 7 3.4 凸凹模刃口尺寸计算 8 4 模具总体结构 11 4.1 模具类型的选择 11 4.2 定位方式的选择 11 4.3 卸料出件方式的选择 12 4.4 导向方式的选择 12 5 落料模具主要零部件基本结构和尺寸 14 5.1 凹模 14 5.2 凸模 14 5.3 其他零部件 14 5.4 定位零件的设计 15 5.