瓦锡兰主机RT-flex资料之二（彩色）.ppt

? W?rtsil? Land Sea Academy Page * Chapter 40 * The opening and closing of the starting pilot valves 2.07 is controlled by the corresponding FCM, depending on the crank angle. The nominal opening angle is 0°, closing angle is 110°. For engines with a large cylinder number the closing angle can be reduced in order to save starting air. The automatic starting valve 2.03 is activated by solenoids ZV70113C and ZV7014C via FCM-20 #1 and FCM-20 #2, if the remote control sends a START signal over the bus. For slow turning and slow turning failure reset the remote control sends separate signals to FCM-20 #1 and FCM-20 #2. The slow turning speed can be adjusted in the WECS-9520 parameters by adopting pulse cycles. Additionally an Air Run signal enables to blow the engine with start air. Starting Valve Control 2.07 2.03 ? W?rtsil? Land Sea Academy Page * Chapter 40 * Starting Valve Control To show the scope of supply of W?rtsil? ? W?rtsil? Land Sea Academy Page * Chapter 40 * Standard System “Kongsberg” CA 2 Control Room WECS-9520 Serviceport CANopen Module Bus #1 #2 Crank-Angle SSI Bus CANopen System Bus FCM-20 Cyl. 1 FCM-20 Cyl. 2 FCM-20 Cyl. 3 FCM-20 Cyl. 5 FCM-20 Cyl. 6 FCM-20 online spare FCM-20 Cyl. 4 Servo oil Pump Servo oil Pump For engines with more than 6 cylinders CA 1 E90 SIB E95.1 RT-flex Engine E95.6 Power Supplies 2 x 230VAC Actuator for Fuel Pump Engine room Rail Unit CANopen / PWM VCU 3x ICU Starting Valve Local Manual Panel ECR Manual Panel CANopen Module Bus #3 CANopen Module Bus #4 Actuator for Fuel Pump Servo oil Pump CO Pump Actuator for Fuel Pump Servo oil Pump CO Pump Actuator for Fuel Pump 4-20 mA flexView OPI OPI ? W?rtsil? Land Sea Academy Page * Chapter 40 * The WECS-9520 system is built with a single multifunctional electronic module FCM-20 = Flex Control Module 20. One FCM-20 is mounted per cylinder in a cabinet (E95) below the rail unit. An additional online spare module FCM-20 is located in