瓦锡兰主机RT-flex资料之五（彩色）.ppt

* ? W?rtsil? * Pulse Lubrication System / A. Spicher Mechanical Installation Servo oil return Lub oil supply Servo oil supply * ? W?rtsil? * Pulse Lubrication System / A. Spicher Mechanical installation * ? W?rtsil? * Pulse Lubrication System / A. Spicher Electrical installation CAN-bus communication cable from FCMs to ALMs and among ALMs: must be special DATA-BUS cable 2x0.5+S (107.038.886.001) Wiring from E95.x (last and second last cyl.) to E41.x Power supply cables to ALM-20: 2x2.5 (107.341.141.017) Wiring from E90 to E41.x Cables to pressure transmitter and solenoid valve: 2x0.75 (107.341.141.003) Cabling according guideline 107.351.157! * ? W?rtsil? * Pulse Lubrication System / A. Spicher RPLS related tools Tool for accumulator-charging 107.382.420a (Gr.9472) For charging procedure refer to Vogel-Manual (99.9% Nitrogen) Accumulator is delivered ready to operate * ? W?rtsil? * Pulse Lubrication System / A. Spicher Spare parts cylinder lubrication RPLS: List of spare parts 107.396.043 (Gr.9605), valid for RT-flex68-D 107.366.930f for other engines 107.387.008b for duplex filter * ? W?rtsil? * Pulse Lubrication System / A. Spicher Commissioning * ? W?rtsil? * Pulse Lubrication System / A. Spicher Flushing See ?Instruction for flushing of Pulse Lubrication System“ 107.371.720 Above mentioned document was made for flex96C-B and flex84T-D but can be adapted to smaller engines Basically, the servo oil supply piping and lubrication oil supply piping are flushed with servo oil (with servo oil rail pressurized by service pump) Oil cleanliness acc. NAS classes * ? W?rtsil? * Pulse Lubrication System / A. Spicher Flushing To Crank case Shut-off valves for Lub.oil and servo oil supply closed * ? W?rtsil? * Pulse Lubrication System / A. Spicher Commissioning procedure Rough procedure: Check of CAN-Bus wiring (el.resistance 60 Ohm and polarity) Power supply cabling polarity check SW-dow