F1554中文.docx

Designation: F 1554 –07aStandard Specification for Anchor Bolts, Steel, 36, 55, and 105-ksi Yield Strength1 This standard is issued under the fixed designation F 1554; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval.1. Scope1.1 This specification covers straight and bent, headed and headless, carbon, carbon boron, alloy, or high-strength low-alloy steel anchor bolts (also known as anchor rods). TheAnchor bolts are furnished in three strength grades, two thread classes, and in the sizes specified in Section 4. 1.2 The anchor bolts are intended for anchoring structural supports to concrete foundations. Such structural supports include building columns, column supports for highway signs, street lighting and traffic signals, steel bearing plates, and similar applications.1.3 Supplementary requirements are included to provide for Grade 55 weldable steel，permanent manufacturers and grade identification, and impact properties for Grades 55 and 105. 1.4 Zinc coating requirements are included in Section 7 forApplications requiring corrosion protection.1.5 The recommended grade and style of nut and washer are included in 6.6 and 6.7 for each grade.1.6 This specification does not cover the requirements for mechanicalexpansion anchors, powder-activated nails or studs, or anchor bolts fabricated from deformed bar.1.7 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.2. Referenced Documents2.1 ASTM Standards:A 194/A194M Specification for Carbon and Alloy SteelNuts for Bolts for High-Pressure and High-Temperature Service3A 370 Test Methods and Definitions for Mechanical Testing of Steel Products4A 563 Specification for Carbon a