Installation procedure for Main Generator主机安装程序.docVIP

Installation workmanship- Main Generator Installation INDEX 目 录 1. Scope - 适用范围 3 2. Reference document – 参考文献 3 3. General of equipment–设备概述 3 4. Preparation before installation – 安装准备 3 5. Installation procedure – 安装过程 4 6. Verify the resilient mounts internal buffers 检查减震垫的缓冲螺杆 5  1. Scope - 适用范围 This Specification is used for Wartsila generating sets installation. 本工艺适用于Wartsila船舶柴油发电机组的安装。 2. Reference document – 参考文献 This procedure is made according to manufacture’s installation operation instruction and related drawings. Shipyard practice and experience are incorporated. 这一工艺是按照制造厂家的安装和操作说明进行编写，并结合船厂的习惯和经验。 3. General of equipment–设备概述 Data of main engine主发电机参数: Manufacturer制造商: Wartsila Type?型号: W12V32 –6pcs Length长: 10123 mm Width 宽: 3060mm Hight 高: 4255mm Weight(wet)湿重: 99345Kg 4. Preparation before installation – 安装准备 4.1 Before launching, the insert deck plate has been welded and the strengthen frame under foundation has been assembled and welded. Related structure blocks should be finished. 船舶下水前，发电机座下面的加厚板及加强结构装配焊接完毕，相关分段的合拢及焊接完毕。 4.2 The foundation for the common base frame must be rigid enough to carry the load from the generating set 发电机组的底座应有足够刚性承受来自发电机的载荷。 4.3 It is suggested that the contour line of resilient mounts should be lined out on the seating top plate according to main installation drawing which is as reference for primary positioning of main engine. 建议在发电机进舱前，根据主机安装图提供的理论位置，在主机座面板上划出主机座外轮廓线，作为发电机初步定位时参考. 4.4 Check that the foundation top plates are flat by standard of vessel quality inspection. 检查主机基座面板水平度符合船质量要求。 ?: Spanner 扳手 Locksmith hammer 钳工锤 Punch 样冲 Chock 划针?: 主机安装应准备以下图纸： Main engine installation drawing主机安装图 401P Block structure drawing 401P分段结构图 401S Block structure drawing 401S分段结构图 402P Block structure drawing 402P 分段结构图 402S Block structure drawing 402S 分段结构图 4.7 Protection of the resilient mounts